Kingston ValueRAM 8GB 1600MHz DDR3L CL11 SODIMM Single RAM

Kingston ValueRAM 8GB 1600MHz DDR3L CL11 SODIMM Single RAM

in stock

ر.س 255

• JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V) Power Supply
• VDDQ = 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V)
• 800MHz fCK for 1600Mb/sec/pin
• 8 independent internal bank
• Programmable CAS Latency: 11, 10, 9, 8, 7, 6
• Programmable Additive Latency: 0, CL – 2, or CL – 1 clock
• 8-bit pre-fetch
• Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
• Bi-directional Differential Data Strobe
• Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
• On Die Termination using ODT pin
• Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°C
• Asynchronous Reset
• PCB: Height 1.18” (30mm), double sided component

in stock

- +
رمز المنتج: KVR16LS11/8 التصنيفات: , ,

This document describes ValueRAM’s 1G x 64-bit (8GB)
DDR3L-1600 CL11 SDRAM (Synchronous DRAM), 2Rx8, low
voltage, memory module, based on sixteen 512M x 8-bit FBGA
components. The SPD is programmed to JEDEC standard
latency DDR3-1600 timing of 11-11-11 at 1.35V or 1.5V. This
204-pin SODIMM uses gold contact fingers. The electrical and
mechanical specifications are as follows:


CL(IDD): 11 cycles
Row Cycle Time (tRCmin): 48.125ns(min.)
Refresh to Active/Refresh Command Time (tRFCmin): 260ns(min.)
Row Active Time (tRASmin): 35ns(min.)
Maximum Operating Power: (1.35V) = 2.721W*
UL Rating: 94 V – 0
Operating Temperature: 0 C to +85 C
Storage Temperature: -55 C to +100 C

*Power will vary depending on the SDRAM used.


الوزن 0.5 kg


لا توجد مراجعات بعد.

كن أول من يقيم “Kingston ValueRAM 8GB 1600MHz DDR3L CL11 SODIMM Single RAM”

Start typing and press Enter to search

عربة التسوق

لا توجد منتجات في سلة المشتريات.